Industrial And Mining Accessories Resin Capsule For Resin Anchor Rock Bolt

As a leading manufacturer of industrial and mining resin accessories, ZF Mining is committed to providing global mining operators with reliable, high-performance chemical anchoring systems. Our production facility is equipped with advanced automated lines to ensure that every resin capsule meets rigorous international safety and durability standards.

Resin anchoring agent is made of unsaturated polyester resin, curing agent, accelerator and other auxiliary materials, according to a certain proportion of the viscous form of anchoring bonding material, by polyester film divided into packages in the form of medicine rolls, with fast curing at room temperature, high adhesive strength, reliable anchoring force and durability and other good performance.

Every batch of our mining resin accessories undergoes strict quality control, including:

 Gel Time Consistency Test: Ensuring the setting speed is accurate for site use.

 Viscosity Measurement: Guaranteeing optimal mixing with rock bolts.

 Compression Strength Analysis: Testing to ensure the resin exceeds 60-70 MPa.

 ISO 9001 Certified Production: Following the highest global manufacturing protocols.

We don't just provide resin; we provide a complete industrial resin anchoring solution. Our accessories are designed to work perfectly with:

 Threaded Bar Rock Bolts

 Steel Domed Plates & Washers

 Cable Bolts for large-scale excavations

 Installation tools and accessories

Operation procedure
1 Select the specification and type of anchoring agent according to the diameter of the drilling hole.
2 According to the specification of anchoring agent required by planning and length of pole, determine the depth of drilling hole which is 60-80㎜ shorter than the whole length of pole.
3 Clean the floating dust in the eye hole with pressurized air.
4 According to the planning anchoring length, use the rod to send the anchoring agent into the bottom of the hole, start the mixer to drive the rod to rotate and mix (mixing time is 8-15s for ultra-fast type; 20-35s for other types), and push it to the bottom of the hole at an even speed.
5 After removing the mixer, the rod should be fixed in the hole in time, and the rod should not be shifted or shaken before curing. Test the anchoring force after 10 min of super fast, 15 min of fast and 30 min of medium speed.
6 Super-fast, fast and medium-speed were 10-60s, 90-180s, 480s after the upper pallet tighten the nut can be loaded.

FEATURES
• Easy and quick to use.
• Can be used for overhead anchorages.
• Produces strong, rapid and consistent anchorages.

• Bolts protected from corrosion and chemical attack.
• No expansion stresses – can be used in weak or relatively soft material.
• Unaffected by vibration.
• Factory controlled high quality product.
• Higher compressive strength.
• Higher modulus.